Your TelosB motes turn on their blue LED once synchronized.UPDATE: Instructions for installation further down the page MSP430 Bootstrap Loader Version: 1.39-telos-8Ĭurrent bootstrap loader version: 1.61 (Device ID: f16c)

Msp430-size firmware/openos/projects/common/03oos_openwsn_progĤ145162 b06a firmware/openos/projects/common/03oos_openwsn_prog In my case, I have 3 motes sudo scons board=telosb toolchain=mspgcc bootload=/dev/ttyUSB2 oos_openwsn You can repeat the same procedure for the other boards. The penultimate line indicates that this TelosB is attached to /dev/ttyUSB0. ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver usb 1-3.3.2: FTDI USB Serial Device converter now attached to ttyUSB0 usb 1-3.3.2: Endpoint 2 MaxPacketSize 64 usb 1-3.3.2: Endpoint 1 MaxPacketSize 64 ftdi_sio 1-3.3.2:1.0: FTDI USB Serial Device converter detected USB Serial support registered for FTDI USB Serial Device usbcore: registered new interface driver ftdi_sio USB Serial support registered for generic usbcore: registered new interface driver usbserial_generic usbcore: registered new interface driver usbserial usb 1-3.3.2: Product: Crossbow Telos Rev.B usb 1-3.3.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-3.3.2: New USB device found, idVendor=0403, idProduct=6001 usb 1-3.3.2: new full-speed USB device number 5 using ehci_hcd You can read this in the web interface (under 'EUI-64'). The remainder of a mote's IPv6 address is it's MAC address (or EUI-64). This means that the IPv6 address of each mote will start with ' bbbb::'. this is hard-coded in the software), the IPv6 prefix of the simulated network is bbbb:/64. You can select other motes and see that they join the network and obtained the same prefix bbbb::/64.Ĭongratulations, you have built your first OpenWSN simulated network! Ping a moteīy convention (i.e. You just declare mote 1 to be the root of your network (the DAGroot in RPL parlance, the sink in WSN parlance, the gateway, etc). Set up the topology to have a chain 1-2-3, and set each PDR to 1.īack in the 'Motes' tab, select mote 0001 and click on the 'Toggle' button. left-click on a link to change its PDR (packet delivery ratio).Confusing, right?Īlso, to create a link, you need to right-click on both endpoints.

You need to right-click on the red balloon, not the blue rectangle. ~/Desktop/openwsn/openvisualizer$ sudo scons runweb -sim

Install wireshark ubuntu 18.10